|
AR24A-A
|
ADSL
2+Router(4-port,
Annex A) |
Features:
Compliant to the
most updated
ADSL2/2+ standards
Realtek Chipset
solution
4x RJ-45 10/100M LAN
ports and 1x RJ-11
WAN port
Support PPPoE
(RFC-2516) and PPPoA
(RFC-2364)
Support Bridge mode
and Routing
Support DHCP, NAT,
Dynamic DNS, and DMZ
host
Support WEP, WPA,
WPA2, and IEEE
802.1x based
Encryption
Firewall support MAC
filtering and IP
filtering
Support WDS
Support 8 PVCs
Support UpnP
Support ACL (Access
Control List)
Easy installation
and configuration
via WEB interface
|
|
Specifications :
ADSL Specification Compliance
ANSI T1.413 Issue2
ITU-T G.992.1 (G.dmt)
ITU-T G.992.2 (G.lite)
ITU-T G.994.1 (G.hs)
ITU-T G.992.3 ADSL2 G.dmt.bit
ITU-T G.992.4 ADSL2 G.lite.bis
ITU-T G.992.5 ADSL2+
Auto-negotiating rate adaptation
Annex A (ADSL over POTS) , Annex
L(ReADSL)
Maximum downstream rate of 24 Mbps
and upstream rate of 1 Mbps
Supports Dying Gasp
Software Specification
RFC-1483/2684 LLC/VC-Mux
bridged/routed mode
RFC-1577 Classical IP over ATM
RFC-2516 PPPoE
RFC-2364 PPPoA
RFC-1661 PPP
Bridge/Routing
DHCP Client/Sever/Relay
IP routing : RIP v1/v2
Static route
DNS Relay Agent
Dynamic DNS
IGMP Proxy
802.1d Spanning-Tree Protocol
NAT (Network Address Translation)
NAPT port forwarding
DMZ support
Security
User authentication for PPP
PAP (Password Authentication
Protocol)
CHAP (Challenge Authentication
Protocol)
Firewall
IP/Port filtering
MAC filtering
ATM
ITU-T 1.610 F4/F5 OAM send and
receiver loop-back
ATM QoS : CBR, rt-VBR, nrt-VBR and
UBR
Multiple PVC : support 8 PVCs
Management
Web-based configuration
Telnet remote management
SNMP v1/v2/Trap
Diagnostic tool
Firmware upgrade through FTP, TFTP
and HTTP
UPnP support
ACL (Access Control List)
Hardware Interfaces
4x RJ-45 ports for 10/100 Base-T
Ethernet LANs connect to PC
1x RJ-11 port for ADSL connects to
WAN
1x reset button to default setting
1x power jack
1x power switch on/off
LED indicators
Power Specification
AC power adaptor: 220 VAC, 50/60Hz
(can be customized)
AC voltage: 12V, 1.0A
Environmental
Specification
Temperature:
-0 to 40 degrees
C (Standard Operating)
-40 to 70 degree
C (Non-operating)
Humidity:
-10% to
90% (Non-condensing, Standard
Operating)
-5% to
95% (Non-condensing, Non-operating)
Vibration: IEC 68-2-36, IEC 68-2-6
Shock: IEC 68-2-29
Drop: IEC 68-2-32
|